DCS User Manual EN.pdf

ED [DCS USER MANUAL]
Like the Search Then Engage Enroute Task, the Search Then Engage In Zone Enroute
Task can be used to create scenarios where the air group maintains a holding pattern
and leaves it to attack discovered enemy units within the target area and the limitations
set by the task properties. To do this, create the Search Then Engage in Zone Enroute
Task in the actions list after the Orbit Task.
Search Then Engage Group
Analogous to the Attack Group Task, but requires the attacking group to independently
detect the target group prior to conducting an attack.
Target Panel
GROUP. Drop down menu to select the target group from all applicable enemy groups
available in the mission.
WEAPONS. Drop down menu to select the weapon types cleared to use for this action.
PRIORITY. This number is used to set the action priority in relation to other actions of
the waypoint. The priority number represents the order this action will take relative to
other actions, starting with '0' as the highest priority.
The Search Then Engage Group Task can be used to create scenarios where the air
group maintains a holding pattern and leaves it to attack the designated group
166 DCS USER MANUAL