DCS User Manual EN.pdf

ED [DCS USER MANUAL]
within the next 30 minutes. If you were to specify 0:15 in the After field, the failure will
occur with set probability within the next 30 minutes after 15 minutes after takeoff.
Additionally, you can adjust the probability of failures by adjusting the Probability (%)
field using the arrow buttons. The Probability ranges between 0% (no chance) to 100%
(certain failure). Note that failure(s) only apply to the Player aircraft.
Along the left side of the window is the DEVICE list that can be used to set an in-mission
failure.
To the right of each device line is a set of fields that allow you to set a time frame from
mission start that the failure will occur and the probability that the failure will occur.
AFTER (hh:mm). Input the hour and minutes from mission start that the failure
will occur.
WITHIN (mm). Use the third field to determine the time that the failure may
happen.
The PROBABILITY (%) field allows you to enter the probability as a percentage
(0 – 100) that the failure will occur in the mission.
The steps needed to set aircraft failures include:
1. Check the checkbox of the desired failure.
2. Set the time at or after which the failure is to take place (hh:mm).
3. Set the time within which the failure is to take place (mm).
4. Set the probability for the failure to occur (%).
134 DCS USER MANUAL