DCS User Manual EN.pdf

ED [DCS USER MANUAL]
In addition to selecting a specific group unit as a target, the Attack Unit Task can be
used to designate a static object as a target using the STATIC drop-down menu or by
left-clicking a static object on the map. This task also allows the mission designer to set
the amount of munitions to expend and number of attack runs.
Target Panel:
GROUP. Drop down menu to select the target group from all applicable enemy groups
available in the mission.
UNIT. Drop down menu to select the specific unit of the target group to attack.
STATIC. Drop down menu to select a static object as the target (bunker, FARP, etc.)
WEAPONS. Drop down menu to select the weapon types cleared to use for this action.
EXPEND. The amount of payload cleared to expend in executing this action.
MAX ATTACK QTY. The maximum number of attack runs cleared for this action.
GROUP ATTACK. When checked, the entire flight group will participate in the attack of
the target. By default, each aircraft in a flight group is assigned one target.
151 DCS USER MANUAL