DCS User Manual EN.pdf

ED [DCS USER MANUAL]
Note: the Attack Group Task assumes full situational awareness for the attacking group.
The target's location will always be known and the group will always attempt an attack if
conditions permit.
The target group can be designated by selecting it from the GROUP drop-down menu in
the Lower Action Properties Panel or by left-clicking over the target group on the map.
When designated as the target, a red triangle appears over the target group and a
dashed line connects the target triangle to the waypoint of the action.
The Lower Action Properties Panel also allows you to set the specific weapon type for
the attacking group to employ against this target or, alternatively, leave this choice up
to the AI using the default "Auto" setting. If a specific weapon type is set, but the attack
is not possible using this weapon type (for example, if the weapon type is missing from
the payload or has been exhausted), the attack will not be performed.
Target Panel:
GROUP. Drop down menu to select the target group from all applicable enemy groups
available in the mission.
WEAPONS. Drop down menu to select the weapon types cleared to use for this action.
AUTO. Automatic selection of weapons by the AI.
Unguided. Unguided bombs, rockets, cannon.
149 DCS USER MANUAL