PROJECT MANUAL Specifications Seafood Removal Walmart Store No 1186 Liberty TX

3.6 FINISH REQUIREMENTS:
A. Gloss: Final surface gloss shall be a Specified Overall Gloss Value (SOGV) of not less than 40, and Minimum
Local Gloss Value (MLGV) of 30 as measured using a Horiba IG-320 Gloss Checker.
B. Gloss: Final surface gloss shall be a Specified Overall Gloss Value (SOGV) of not less than 50 and Minimum
Local Gloss Value (MLGV) of 40 as measured using a Horiba IG-320 Gloss Checker.
C. Slip Resistance: Measured static coefficient of friction (SCOF) shall be not less than 0.50 at time of Re-Grand
Opening as measured using an American Slip Meter ASM 825 Digital Meter, Regan Scientific Instruments BOT-
3000 Tribometer, or approved equal.
3.7 FLOOR PROTECTION
A. Protect finished floor from construction traffic and weather until time of Re-Grand Opening.
B. Do not allow water or other liquids to come in contact with finished floor for 72 hours after protective treatment
application.
C. Do not allow acids and acidic detergents to come in contact with slab.
3.8 PRODUCT DISPOSAL
A. Upon completion of densifier and protective treatment, dispose of excess materials as required by local agency
having jurisdiction.
B. Certified applicator shall remove densifier and protective treatment product containers from job site immediately
upon completion of treatment.
3.9 QUALITY ASSURANCE TESTING (BY OWNER)
A. Testing will be performed by Wal-Mart’s Construction Testing Laboratory (CTL) at no expense to the
Contractor. A test report of all measurements and a plan and table of the measurements taken will be prepared by
the CTL for submission.
B. Gloss measurements will be taken once weekly prior to Substantial Completion and at Re-Grand Opening.
Contractor shall notify CTL when floors are ready for testing.
C. Measurement and reporting of SOGV and MLGV by CTL shall be as follows:
1. Collect a minimum of three samples per each bay in random, evenly distributed locations.
2. Record measurement locations on copy of Floor Plan.
3. The average of all samples collected in each bay shall meet or exceed the specified SOGV.
a. If the average of samples collected do not meet the SOGV, collect an addition 3 samples in each
bay for each deficient result unless the individual samples fail to meet the MLGV or the average
of all collected samples in each bay fail to meet the SOGV.
b. If samples fail to meet the SOGV, Contractor shall continue sweeping, scrubbing and polishing
until the SOGV is achieved.
4. No single measured value shall be less than MLGV.
a. If one or more samples fall below the MLGV, Contractor shall continue sweeping, scrubbing
and polishing until all samples comply with Specified MLGV and SOGV.
5. Collect and certify final gloss measurements.
D. Slip Resistance Measurements:
03362-6
Walmart #1186 – Liberty, TX 04/20/11
CMA/10118.034