PROJECT MANUAL Specifications Seafood Removal Walmart Store No 1186 Liberty TX

UniSpec II-Store Planning 032610
SECTION 16121 - MANUFACTURED WIRING SYSTEMS
PART 1 - GENERAL
1.1 SUMMARY
A. Section Includes:
1. Manufactured Wiring Systems.
B. Products Installed But Not Supplied Under This Section:
1. Owner will furnish prefabricated flexible cable assemblies and required accessories as indicated on Drawings.
2. Contractor shall provide related products required to complete installation.
C. Related Sections:
1. Section 01640 - Owner Furnished Products: General procedures related to Owner furnished products.
2. Section 16100 - Wiring Methods: Wire color coordination.
3. Section 16500 - Lighting: National accounts vendor.
1.2 REFERENCES
A. National Fire Protection Association (NFPA):
1. NFPA 70 - National Electrical Code (NEC).
1.3 DELIVERY, STORAGE AND HANDLING
A. Provide for delivery of installation drawings and product at such stage of construction as will expedite the Work.
B. Contact selected vendor for product delivery. Allow minimum of four weeks for delivery.
C. Provide proper facilities for handling and storage of materials to prevent damage. Keep materials dry and fully
protected from weather.
D. Upon receipt of shipment, check contents of shipment against bill of material furnished by the selected vendor.
Report any shortages or damage to the selected vendor immediately so that replacements can be ordered and/or
freight claims can be filed. Note damage on Bill of Lading in order to substantiate freight claims.
PART 2 - PRODUCTS
2.1 MANUFACTURED WIRING SYSTEMS
A. Prefabricated Flexible Cable Assemblies: Factory pre-assembled units consisting of pre-wired cable assemblies
and appropriate connectors. Units will comply with the following:
1. Cable Assemblies: Flexible armor jacket with thermoplastic insulated, #12 AWG, solid, copper conductors.
Number of conductors in each cable assembly as required by application. Allow minimum of 12 inch
extra length, in addition to required length to reach point to point, for each cable assembly.
2. Connectors: Injection molded thermoplastic compound with up to six copper alloy contact sleeves/pins for
positive contact. Provide connectors with 2 positive locking latches, rated for 20 amps, and designed to
make or break under load. Attachment to cable shall be set screw type.
3. Cable assemblies will be white in color.
4. Wire phase colors will match colors as specified in Section 16100.
5. Cable assemblies and their related accessories shall bear the UL Label.
16121-1
Walmart #1186 - Liberty, TX 04/20/11
CMA/10118.034