PROJECT MANUAL Specifications Seafood Removal Walmart Store No 1186 Liberty TX

C. Work shall be preformed by a Special Inspector – Technical I unless specified otherwise. Report of testing and
inspection results shall be made upon the completion of testing.
D. Classification of Materials: Perform test for classification of materials used and encountered during construction in
accordance with ASTM D2488 and ASTM D2487.
E. Laboratory Testing Of Materials: Perform laboratory testing of materials (Proctor, Sieve Analysis, Atterberg
Limits, Consolidation Test, etc.) as specified.
F. Field Density Tests.
1. Utility Trench Backfill: Intervals not exceeding 30-feet of trench for first and every other 8-inch lift of
compacted trench backfill.
2. Test Method: In-place nuclear density, ASTM D 2922 (Method B-Direct Transmission).
G. Corrective Measures For Non-Complying Compaction: Remove and recompact deficient areas until proper
compaction is obtained at no additional expense to Owner. Adjust moisture content as necessary to conform to the
requirements of this section.
H. Observation and Inspection:
1. Observe all subgrades/excavation bases below slabs and verify design bearing capacity is achieved as
required. Work shall be performed by a Special Inspector – Technical II.
2. Observe and document presence of groundwater within excavations.
END OF SECTION
02320-6
Walmart #1186 – Liberty, TX 04/20/11
CMA/10118.034