PROJECT MANUAL Specifications Seafood Removal Walmart Store No 1186 Liberty TX

1. Supplier: Local Sherwin-Williams store, as follows:
a. Contact Name: Bobby Clark
b. Supplier Store Number: 7002
c. Store Address: 2323A N. Main Street, Liberty, TX 77575
d. Store Phone number: 936-336-3586
B. Acceptance at Site: Receive products as specified in Section 01640.
1. Verify quantity of products furnished with Bill of Material provided with Wal-Mart furnished products.
2. Report discrepancies in product quantity delivered or damage to Supplier.
3. Upon notification by Contractor, Supplier will arrange for delivery of replacement products.
4. Note description of product quantity discrepancies and/or product damage on Bill of Materials.
C. Paint orders shall identify the store number, location, and address of project.
D. Delivery of paint materials shall be in sealed original labeled containers, bearing manufacturer's name, type of
paint, brand name, lot number, brand code, coverage, surface preparation, drying time, cleanup requirements, color
designation, and instructions for mixing and/or reducing. Notify Supplier when delivered products to not conform
to these requirements.
1.6 ENVIRONMENTAL REQUIREMENTS
A. Apply paint finishes only when moisture content of surfaces is within manufacturer's acceptable ranges for type of
finish being applied.
B. Minimum surface temperatures or ambient air temperature shall be as follows for the specified coatings unless otherwise
specifically stated by the manufacturer for the specific coating:
1. Alkyd and interior latex finishes: 50 degrees F.
2. Varnish and transparent finishes: 65 degrees F.
3. All coatings: 5 degrees F above dew point.
C. Provide continuous ventilation and heating facilities to maintain temperatures above the manufacturer’s stated
minimum surface and air temperature for 24 hours prior to, during, and 48 hours after application of finishes.
D. Do not apply paint in areas where dust is being generated.
E. Expose waste paint to air and allow paint to dry.
F. Remove bulk from container and dispose in accordance with MSDS data and local environmental regulations for
paint products. Clean containers and recycle.
G. Provide lighting level in areas being painted of 80 foot candles measured mid-height at substrate surface.
PART 2 - PRODUCTS
2.1 OWNER FURNISHED PRODUCTS
A. Products Supplied by Wal-Mart Supplier and Installed by Contactor: Under provisions of Section 01640, Wal-
Mart’s supplier will furnish a limited portion of the specified products in the quantities as specified hereinafter on
the Wal-Mart furnished Quantity Schedule for installation by the Contractor.
1. Wal-Mart supplied products will conform to the specifications included in this section.
2. Wal-Mart Supplier: Sherwin Williams Company. Contact: Kevin Behm, (216) 566-1558,
Kevin.c.behm@sherwin.com
B. Products Provided (Furnished and Installed) by the Contractor: The Contractor shall provide all products specified
herein which are not scheduled to be Wal-Mart furnished.
09900-2
Walmart #1186 – Liberty, TX 04/20/11
CMA/10118.034