PROJECT MANUAL Specifications Seafood Removal Walmart Store No 1186 Liberty TX

UniSpec II- Store Planning 022610
SECTION 05500 - METAL FABRICATIONS
PART 1 - GENERAL
1.1 SUMMARY
A. Section Includes:
1. Shop fabricated ferrous metal items, galvanized and prime painted.
2. Wal-Mart furnished fabricated metal items.
B. Products Installed But Not Furnished Under This Section:
1. Under provisions of Section 01640, Wal-Mart's metal fabrication suppliers will furnish the following
fabricated metal items for installation by Contractor.
a. Jib crane hoist arm and railing assembly.
b. Roof parapet camera support assembly (Tri-Mount).
c. AP Monitor support assembly –wall and ceiling mounting.
d. Interior Stainless Steel Bollards – Floor Mounted/Bolted.
e. Floor Mounted Railings.
C. Related Sections:
1. Section 01458 - Testing Laboratory Services: Testing and inspection.
2. Section 01640 - Owner Furnished Products: General procedures related to Wal-Mart furnished products.
3. Section 09900 - Paints and Coatings: Field painted finishes.
1.2 REFERENCES
A. The publications listed below form a part of this specification to the extent referenced. Publications are referenced
within the text by the basic designation only.
B. American National Standards Institute (ANSI):
1. ANSI A 14.3 – Ladders, Fixed, Safety Requirements.
C. ASTM International (ASTM):
1. ASTM A 36 - Carbon Structural Steel.
2. ASTM A 53 - Pipe, Steel, Black and Hot-Dipped, Zinc-Coated Welded and Seamless.
3. ASTM A 307 - Carbon Steel Bolts and Studs, 60,000 psi Tensile Strength.
4. ASTM A 325 - Structural Bolts, Heat Treated, 120/105 ksi Minimum Tensile Strength.
5. ASTM A 500 - Cold-formed Welded and Seamless Carbon Steel Structural Tubing in Rounds and Shapes.
6. ASTM A 591 - Steel Sheet, Electrolytic Zinc-Coated, for Light Coating Mass Applications.
7. ASTM A 653 - Steel Sheet, Zinc-Coated (Galvanized) or Zinc-Iron Alloy-Coated (Galvannealed) by the
Hot-Dip Process.
8. ASTM A 1008 - Steel, Sheet, Cold-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength
Low-Alloy with Improved Formability, Solution Hardened, Baked Hardenable.
9. ASTM A 1011 - Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy and
High-Strength Low-Alloy with Improved Formability.
D. American Welding Society (AWS):
1. AWS D1.1 - Structural Welding Code.
2. AWS D1.3 - Structural Welding Code - Sheet Steel.
E. Steel Structures Painting Council (SSPC):
1. SSPC-Paint 20 Type II - Zinc Rich Primers - Organic.
2. SSPC-Paint 25 - Red Iron Oxide, Zinc Oxide, Raw Linseed Oil, and Alkyd Primer.
05500-1
Walmart #1186 – Liberty, TX 04/20/11
CMA/10118.034