PROJECT MANUAL Specifications Seafood Removal Walmart Store No 1186 Liberty TX

More documents

Recommendations

Info

PULSE METER LETTER Cutler-Hammer IQ 200 Electrical Distribution System Meter System Frequency Wiring Configuration Current Transformer Ratio Potential Transformer Ratio Demand Window KYZ Output Setting Energy per Pulse Rate Example: System Frequency 60 Hz Wiring Configuration 4 wire Current Transformer Ratio 1200/5 Potential Transformer Ratio N/A Demand Window 5 min KYZ Output Setting KWh Energy per Pulse Rate 1 13810-19 Walmart #1186 - Liberty, TX 04/20/11 CMA/10118.034
PHASE LOSS INFORMATION How many phase loss monitors exist in store? _____________ Phase loss sensor cable wired between the common and the normally closed contacts? Yes________ if no, explain____________________________________________________ Input to global network controller (GNC) is connected to phase loss input terminals? Yes________ if no, explain____________________________________________________ 480 volts to phase loss monitor(s)? Yes ________ What panel and circuit feed 480vac to phase loss monitor(s)? Panel: ____________________________ Circuit Breaker: _________________________ Panel: ____________________________ Circuit Breaker: _________________________ Panel: ____________________________ Circuit Breaker: _________________________ Panel: ____________________________ Circuit Breaker: ________________________ Panel: ____________________________ Circuit Breaker: _________________________ VOLTAGES PLS #1 PLS #2 PLS #3 PLS #4 PLS #5 A To C B To C A To B A To Ground B To Ground C To Ground Phase Loss Sensor Under-Voltage: _________________________ Vac Over-Voltage: _________________________ Vac Delay: _________________________ Seconds Lighting information: Include copy of appropriate electrical drawing(s) indicating type of lighting control used, loads and their power circuits. (Use the one line drawing for the contactors, IFP(s), LCU(s) or Cutler Hammer-1000(s) from electrical drawings in plans.) 13810-20 Walmart #1186 - Liberty, TX 04/20/11 CMA/10118.034
Page 1 and 2:
1300 Summit Avenue Suite 300 Fort W
Page 3 and 4:
UniSpecDOCUMENT 00007 - SEALS PAGE
Page 5 and 6:
SEALS PAGE (Continued) STRUCTURAL E
Page 8 and 9:
UniSpec II - Store Planning 032610
Page 10 and 11:
16050 Basic Electrical Materials an
Page 12 and 13:
A. Limit use of site to allow for:
Page 14:
Page 17 and 18:
A. A $250 administrative cost will
Page 20 and 21:
UniSpec II- Store Planning 012910 S
Page 22 and 23:
Page 24 and 25:
1.4 SCHEDULE UPDATES A. The Contrac
Page 26 and 27:
1.3 TRANSMITTAL A. Transmit each su
Page 28 and 29:
UniSpec II- Store Planning 043010 R
Page 30 and 31:
UniSpec II-Store Planning 111910 SE
Page 32 and 33:
O. Periodic Inspection: The part-ti
Page 34 and 35:
samples. Provide lift equipment as
Page 36 and 37:
Concrete Slabs) 03931 - Existing In
Page 38 and 39:
Page 40 and 41:
NEUTRALIZATION ENCLOSURE CERTIFICAT
Page 42 and 43:
A. Provide, maintain and pay for te
Page 44 and 45:
3. Office space with desk and chair
Page 46 and 47:
1.21 SIGNAGE A. Temporary Construct
Page 48 and 49:
Page 50 and 51:
Not Used END OF SECTION 01600-3 Wal
Page 52 and 53:
D. Remove packaging and clean produ
Page 54 and 55:
Page 56 and 57:
9. The Contractor shall verify exis
Page 58 and 59:
G. Obtain all required inspections
Page 60 and 61:
2. Where a product or type of const
Page 62 and 63:
C. Cleaning materials shall be clea
Page 64 and 65:
12. Touch up and otherwise repair a
Page 66 and 67:
K. Re-Use: The use, in the same or
Page 68 and 69:
G. Supply workers and subcontractor
Page 70 and 71:
Page 72 and 73:
a. Elastomeric Membrane Roofing (Se
Page 74 and 75:
STORE/CLUB TYPE (Check Those That A
Page 76 and 77:
Rubber: VCT: PVC: Ceramic: R.R. Par
Page 78 and 79:
[CONTRACTOR’S LETTERHEAD] CONTRAC
Page 80 and 81:
7. Test soils around buried tanks f
Page 82 and 83:
3. Storage or sale of removed items
Page 84 and 85:
3.4 DISPOSAL OF DEMOLISHED MATERIAL
Page 86 and 87:
Page 88 and 89:
E. Contact Wal-Mart Store Planning
Page 90 and 91:
3.2 INSTALLATION A. Install shoring
Page 92 and 93:
B. Satisfactory Materials: ASTM D 2
Page 94 and 95:
A. Classification of Excavation: Th
Page 96 and 97:
C. Work shall be preformed by a Spe
Page 98 and 99:
2. ACI 301 - Structural Concrete. 3
Page 100 and 101:
e. Data indicating chloride ion con
Page 102 and 103:
1. The concrete floor finishing sub
Page 104 and 105:
excessive exhaust gases containing
Page 106 and 107:
2.3 FORMWORK: A. Forms: 1. Plywood,
Page 108 and 109:
A. Provide admixture products as sp
Page 110 and 111:
average times of initial setting. T
Page 112 and 113:
B. Design, construct, erect, suppor
Page 114 and 115:
4. Space joints to allow one contin
Page 116 and 117:
supplementary cementing materials,
Page 118 and 119:
4. Spread compound evenly using mop
Page 120 and 121:
sieve analysis of material retained
Page 122 and 123:
3. Prevention of stored materials i
Page 124 and 125:
C. MIX DESIGN Cement Coarse Aggrega
Page 126 and 127:
CONTRACTOR'S QUALIFICATION STATEMEN
Page 128 and 129:
TABLE A TESTING AND INSPECTION SCHE
Page 130 and 131:
03312-34 Walmart #1186 - Liberty, T
Page 132 and 133:
2. Limit and control damage from no
Page 134 and 135:
2.4 EQUIPMENT A. Scrubber Machines
Page 136 and 137:
3.6 FINISH REQUIREMENTS: A. Gloss:
Page 138 and 139:
Page 140 and 141:
1. Comply with current Federal and
Page 142 and 143:
2. American Decorative Concrete (80
Page 144 and 145:
1. Pentra-Guard (HP) by Convergent
Page 146 and 147:
E. Continue burnishing operations u
Page 148 and 149:
UniSpec II- Store Planning 073109 [
Page 150 and 151:
3. Notify Walmart Concrete Consulta
Page 152 and 153:
A. Concrete lithium based chemical
Page 154 and 155:
E. Continue burnishing operations u
Page 156 and 157:
Page 158 and 159:
E. Galvanized Steel Sheets: 1. Stru
Page 160 and 161:
H. Interior Stainless Steel Bollard
Page 162 and 163:
F. Finish: Embossed. G. Color: Prov
Page 164 and 165:
Page 166 and 167:
2. In joints where plumbing fixture
Page 168 and 169:
2. Unless noted otherwise, use poly
Page 170 and 171:
INTERIOR JOINTS MATERIAL TO MATERIA
Page 172 and 173:
Page 174 and 175: 3.2 INSTALLATION (BY CONTRACTOR) A.
Page 176 and 177: C. Gypsum Association (GA): 1. GA-2
Page 178 and 179: N. Flat Straps and Plates: ASTM A 6
Page 180 and 181: . Substitutions not permitted. 2. E
Page 182 and 183: together. b. Install optional produ
Page 184 and 185: 3.9 INSTALLATION - GYPSUM BOARD A.
Page 186 and 187: items installed within framing. 3.1
Page 188 and 189: PART 2 - PRODUCTS 2.1 MANUFACTURERS
Page 190 and 191: E. Locate system on room axis accor
Page 192 and 193: f. Kencove vinyl: No. KC213 Granite
Page 194 and 195: UniSpec II - Store Planning 092410
Page 196 and 197: 2.2 MATERIALS A. Paint: Wal-Mart an
Page 198 and 199: 3.4 MECHANICAL AND ELECTRICAL EQUIP
Page 200 and 201: 3.9 PAINT SHEEN SCHEDULE A. Gloss:
Page 202 and 203: tion) Concrete Masonry Unit (Previo
Page 204 and 205: A. Plastic: 1. Clear Plastic: a. Sp
Page 206 and 207: UniSpec II - Store Planning 032709
Page 208 and 209: 2. If the Contractor subcontracts t
Page 210 and 211: PART 2 - PRODUCTS 2.1 ENERGY MANAGE
Page 212 and 213: I. Cable: 1. Provide communication
Page 214 and 215: 13810-9 Walmart #1186 - Liberty, TX
Page 216 and 217: WAL-MART SUPPORT INSTALLATION FORM
Page 218 and 219: PRE-CHECKOUT VERIFICATION FORM HOA
Page 220 and 221: HVAC INFORMATION Rtu # Cool Stage H
Page 222 and 223: CUTLER HAMMER MODULE CONFIGURATIONS
Page 226 and 227: OPERATING INFORMATION Communication
Page 228 and 229: UniSpec II-Store Planning 052209 SE
Page 230 and 231: 3.3 SCHEDULES: Schedules below appl
Page 234 and 235: 3) Coupling Housings: Ductile iron
Page 236 and 237: 2.5 DRAINS, CLEANOUTS, HOSE BIBBS,
Page 238 and 239: E. Install Y-pattern strainers for
Page 240 and 241: B. Contractor Qualifications: Testi
Page 242 and 243: G. Report: 1. Provide summary repor
Page 246 and 247: B. Make an inspection of installed
Page 248 and 249: D. As equipment is received, Refrig
Page 250 and 251: C. Make joints with use of brazing
Page 252 and 253: B. Do not endanger any work by cutt
Page 254 and 255: 15600-11 Walmart #1186 - Liberty, T
Page 258 and 259: 15700-3 Walmart #1186 - Liberty, TX
Page 262 and 263: D. Duct Wrap: ASTM C553. 1. Materia
Page 264 and 265: B. Substitutions: Not permitted. 2.
Page 266 and 267: 3.8 SCHEDULES SCHEDULE I - DUCT SUP
Page 270 and 271: 3.3 TESTING A. Upon completion of i
Page 274 and 275:
2.3 OUTLET BOXES AND CONDUIT FITTIN
Page 276 and 277:
9. GFCI Duplex Receptacle 20A 125V
Page 278 and 279:
7. Single Locking Receptacle 30A 12
Page 280 and 281:
2. Plug 20A 250V 2 Pole 3 Wire Grou
Page 282 and 283:
I. Pin & Sleeve - Insulated Water T
Page 284 and 285:
3. If tank and tank indicators are
Page 286 and 287:
Page 288 and 289:
Page 290 and 291:
show all

PROJECT MANUAL Specifications Seafood Removal Walmart Store No 1186 Liberty TX

Create successful ePaper yourself

Delete template?

Save as template?