BAKER HUGHES - Drilling Fluids Reference Manual

RESERVOIR APPLICATION FLUIDS
REFERENCES
1. Louisiana State University, Louisiana Energy & Environmental Resource & Information Centre,
www.leeric.lsu.edu/bgbb/
2. Completion and Workover Fluids, K. L. Bridges, SPE Monograph Series, 2000.
3. van Velzen, J.F. G and Leerlooijer, K., Impairment of a Water-Injection Well by Suspended Solids :
Testing and Prediction, SPEPF, August 1993.
4. Maly, G.P., Minimizing Formation Damage – 2. Attention to System Details Helps in prevention of
Damage, Oil & Gas Journal, 29 March, 1976.
5. Ali, S.A. et al, Test High-Density Brines for Formation Water Interaction, Petroleum Engineer
International, July 1994.
6. Leontaritis, K,J. and Charles, R.E., A systematic Approach for the Prevention and Treatment of
Formation damage Caused by Asphaltene Deposition, SPEPF, March 1994.
7. Sutton, G.D. and Roberts, L.D., Paraffin Precipitation During Fracture Stimulation, Journal of
Petroleum Technology, September 1974.
8. Dyke, G.G. and Crockett, D.A., Prudhoe Bay Workovers: Best Practices for Minimising Productivity
Impairment and Formation Damage, Paper SPE 26042 presented at the 1993 SPE Western Regional
Meeting, Anchorage, 26 – 28 May.
9. Jones, T.A. And Daves, T., Reservoir Drill-in Fluids: Selection Criteria, Testing Protocol and
Operational Procedures, AADE Drilling Fluids Conference, Houston, Texas, 3 – 4 April 1996.
10. Donovan, J.P. and Jones, T.A., Specific Selection Criteria and Testing Protocol Optimise Reservoir
Drill-in Fluid Design, SPE paper 30104, presented at the European Formation Damage Control
Conference in The Hague, the Netherlands, 15 – 16 May, 1995.
BAKER HUGHES DRILLING FLUIDS
REFERENCE MANUAL
REVISION 2006 6-114