Datascope - Mindray

More documents

Recommendations

Info

Installation Guide Installation Checkout Procedure 13. Perform Compliance Valve Test a. Follow the on-screen instructions. b. Select Continue to start the test. FIGURE 2-10 Compliance Test Setup FIGURE 2-11 Compliance Test in Progress AS3000 Service Manual 0070-10-0683 2 - 15
Installation Checkout Procedure Installation Guide c. Select Continue to prompt to the Normal Screen. FIGURE 2-12 Compliance Test Results 14. Manual Leak Test NOTE: The Manual Leak Test detects smaller leaks than can be detected in the Automatic Leak Test. a. Ensure that the gas pressure for O 2 , N 2 O, and AIR are at 50 ±10 psi. b. Power ON the AS3000. c. Attach a reusable-silicone-rubber breathing circuit to the Breathing System. NOTE: For testing purposes always use a reusable breathing circuit. d. Tightly connect the Y-fitting on the breathing circuit to the test port. e. Attach a breathing bag to the bag arm. f. Set the APL Valve to the fully closed position (70 cmH 2 O). g. Rotate the O 2 Flow Control Valve until 50 cmH 2O pressure is observed on the Airway Pressure Gauge. h. Verify that the flow required to stabilize the pressure is less than 300 mL/min. 2 - 16 0070-10-0683 AS3000 Service Manual
Page 1 and 2:
Datascope AS AnesthesiA Delivery sy
Page 3 and 4:
AS3000 is a U.S. trademark of Mind
Page 5 and 6:
Table of Contents Manual Breathing
Page 7 and 8:
Table of Contents System Self Test.
Page 9 and 10:
Table of Contents This page intenti
Page 11 and 12:
Introduction Cautions WARNING: Comp
Page 13 and 14:
Introduction Notes This page intent
Page 15 and 16:
Microprocessor-controlled Ventilato
Page 17 and 18: Components Theory of Operation 3. U
Page 19 and 20: Components Theory of Operation 14.
Page 21 and 22: Components Theory of Operation 26.
Page 23 and 24: Components Theory of Operation 1.3.
Page 25 and 26: Ventilator Control and Drive Theory
Page 43 and 44: Anesthesia System Components Theory
Page 45 and 46: Ventilator UI Theory of Operation F
Page 47 and 48: Ventilator UI Theory of Operation 1
Page 49 and 50: Ventilator Pneumatic - O 2 Drive Ga
Page 51 and 52: The Breathing System Theory of Oper
Page 53 and 54: The Breathing System Theory of Oper
Page 55 and 56: Assembly Installation Guide 2.2 Ass
Page 57 and 58: Assembly Installation Guide 2. Atta
Page 59 and 60: Assembly Installation Guide 2.2.11
Page 61 and 62: Installation Checkout Procedure Ins
Page 67: Installation Checkout Procedure Ins
Page 81 and 82: Warnings and Cautions Repair Inform
Page 83 and 84: 3 - 4 0070-10-0683 AS3000 Service M
Page 89 and 90: 3 - 10 0070-10-0683 AS3000 Service
Page 99 and 100: Available Replacement Parts and Sub
Page 101 and 102: Isometric Drawings Replacement Part
Page 115 and 116: Calibration Warnings, Precautions,
Page 117 and 118: General Guidelines Calibration 5.3
Page 119 and 120:
Calibration Procedures Calibration
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Periodic Maintenance Schedule of Se
Page 131 and 132:
Check Valve Cleaning Periodic Maint
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Functional Tests Periodic Maintenan
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Preoperative Checklist Periodic Mai
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Phone Numbers and How To Get Assist
Page 177 and 178:
Disclaimers Warranty No agent, empl
Page 179 and 180:
0070-10-0683 Rev J January 11, 2011
show all

Datascope - Mindray

Create successful ePaper yourself

Delete template?

Save as template?