HP 8590 E & L Series Spectrum Analyzers and HP 8591C Cable TV ...

DET
Detection Mode
Selects the spectrum analyzer detection mode.
Syntax
Equivalent Softkey: DETECTOR PK SP NG or DETECTOR SMP PK.
Preset State: DET POS.
Related Commands: DEMOD, MEANTH, TV.
Example
10 OUTPUT 718;"IP;"
20 OUTPUT 718;"SNGLS;"
30 OUTPUT 718;"DET POS;TS;"
40 OUTPUT 718;"VIEW TRA;"
50 OUTPUT 718;"DET SMP;"
60 OUTPUT 718;"CLRW TRB;TS;"
70 OUTPUT 718;"VIEW TRB;"
80 OUTPUT 718;"AVG TRA,TRB,2;"
90 OUTPUT 718;"BLANK TRB;"
100 END
Description
DET Detection Mode
XDET
Initializes the spectrum analy.zer
Activates single-sweep mode.
Activates the positive-peak detection of trace A.
Stores results in trace A.
Activates sample detection for trace I3
Measures with trace B
Stores results in trace B
Averages trace A and B with a ratio of 2, and stores
the results in trace A.
Blanks trace rj leaving on1 y averaged results on screen.
The DET command selects the type of spectrum analyzer detection (positive-peak, sample, or
negative) and accesses service-diagnostic detection functions.
POS enables positive-peak detection, which displays the maximum video signal detected
over a number of instantaneous samples for a particular frequency.
SMP enables sample detection, which uses the instantaneous video signal value. Video
averaging and noise-level markers, when activated, activate sample detection
automatically.
NEG enables negative peak detection in sweep times of less than or equal to 200 ms. The
negative peak detector is available with Option 101 or Option 301 only.
Programming Commands 5-128