HP 8590 E & L Series Spectrum Analyzers and HP 8591C Cable TV ...

Executing a DLP
This section contains information about how to execute a DLP This section contains the
following procedures:
� Execute the DLP by using a softkey.
H Execute the DLP within a program.
To Execute a DIP by Using a Softkey
There are two ways to execute a DLP. You can execute the DLP by pressing a softkey that has
been assigned a function as shown in this procedure, or execute the DLP within a program
(shown in the following procedure).
1. Use the KEYDEF command to assign the function that you created with the FUNCDEF
command to a softkey.
2. Press (j-J, User Menus to access the softkey.
Example
The following example uses the KEYDEF command to assigns the ZBOM function to softkey 1.
10 OUTPUT 718;"KEYDEF 1, Z-OOM,%CAL SIGIZOOM%;"; Assigns thefunction Z-OOMto
soflkey 1 and assigns sofikey 1
the label “CAL SIG ZOOM. ”
20 LOCAL 718
30 END
You can access CAL SIG 2DOM by pressing (-1, User Menus .
lb Execute the DLP within a Program
You can also execute the DLP within a program.
w Use the name of the DLP within a program.
Example
The following programming line executes the Z-OOM function from an external controller.
OUTPUT 718;"Z-0OM;"
Creating and Using Downloadable Programs 4-9