HP 8590 E & L Series Spectrum Analyzers and HP 8591C Cable TV ...

PKDLMODE
Peak Table Delta Display Line Mode
Selects the signal peaks that are displayed in the peak table. The signal peaks can be selected
as follows: all the signal peaks, only the signal peaks that are above the display line, or only
the peaks that are below the display line.
Syntax
.._,_..’
Equivalent Softkey: PK MODE DL NRM .
Preset State: 0 (display all the signal peaks).
Related Commands: DL, PKSORT, PKTBL.
Example
peaks below
r DL ?
-1
01 I
/ peaks \
0
peaks above
r DL I
1
/
XPKDLMODE
OUTPUT 718;“MOV PKTBL,l;” Turns on the peak table.
OUTPUT 718;“DL -20;” Sets the display line.
OUTPUT 718;“MOV PKDLMODE,l;” Displays the on.!?/ the signal peaks that are above the
display line.
Description
The value of PKDLMODE determines how the signal peaks are displayed. You can set
PKDLMODE to the following values:
� If PKDLMODE is set to 0, all signal peaks are displayed and listed.
H If PKDLMODE is set to - 1, only the signal peaks below the display line are displayed and
listed.
H If PKDLMODE is set to 1, only the signal peaks above the display line are displayed and
listed.
You can execute the PKDLMODE command two different ways. You can either execute the
PKDLMODE command directly (for example, “PKDLMODE 1; ‘I) or use the MOV command to
move the 1 or 0 into the PKDLMODE command (for example, I’MOV PKDLMODE, 1; I’). If you use
the MOV command, no text is displayed in the active function area during command execution.
5-428 Programming Commands