HP 8590 E & L Series Spectrum Analyzers and HP 8591C Cable TV ...

LIMIMODE
Limit-Line Entry Mode
LIMIMODE Limit-Line Entry Mode
Determines whether the limit-line entries are treated as upper amplitude values, lower
amplitude values, upper and lower amplitude values, or mid-amplitude and delta values.
Syntax
Related Commands: LIMILINE, LIMISEG, LIMISEGT, SEGDEL, SENTER, SENTERT.
Example
This example uses LIMIMODE to enter segments into the upper limit-line table, and then to
enter a segment into the lower limit-line table (upper and lower limit lines are treated as
separate tables). Line 60 demonstrates entering a segment into a combined upper and lower
limit-line table.
10 OUTPUT 718;"LIMIDEL;" Deletes the current limit-line ta-
20 OUTPUT 718;"LIMIMODE UPPER;"
30 OUTPUT 718;"LIMIFT FREQ;"
40 OUTPUT 718;"LIMISEG 300MHZ,-30DB,SLOPE;"
50 OUTPUT 718;"LIMIMODE LOWER;"
60 OUTPUT 718;"LIMISEG 300MHZ,-70DB,SLOPE;"
70 OUTPUT 718;"LIMIMODE UPLOW;"
80 OUTPUT 718;"SENTER 350MHZ,-30DB,-80DB,FLAT;"
90 OUTPUT 718;"LIMIDISP ON;"
100 END
ble, sets the table type to jixed.
Specifies the upper limit-line table.
Selects a limit line based on frequency.
Enters a segment into the upper
limit-line table. Because the
LMSEG command is used, the
limit-line table will be based on
freq-9.
Spec@.es the lower limit-line table.
Enters a segment into the lower
limit-line table.
SpecQies the upper and lower limitline
tables.
Enters a segment into the upper
and lower limit-line tables.
Displays the limit lines.
Programming Commands 5-281