Table of Contents - Covidien

Getting started
3. Press CLEAR to cancel the most recently changed setting and
return to the last valid setting. (This only works if you haven’t
pressed ACCEPT yet.) Pressing CLEAR after you’ve pressed
100% O2 stops the 100% O2 maneuver. The ventilator will beep
if you attempt to change a setting to a value above or below
the setting range.
4. PEEP/CPAP, TRIGGER SENSITIVITY, and % O2 : You
can change these settings in any mode. These keys
don’t flash when you select a new mode, and you
are not required to confirm these settings.
PEEP/CPAP
NOTE:
The O 2 % alarm is delayed for 30 seconds and 12 L of tidal
volume following a change in setting so that the oxygen
concentration can stabilize.
5. Apply the settings: Press ACCEPT.
ACCEPT
TRIGGER
SENSITIVITY
L/min
NOTE:
If apnea ventilation is possible, the ventilator displays this
message when normal ventilation begins:
Review Ta = xx s
where Ta is the apnea interval and xx is the current setting in
seconds (from 10 to 60 s). Chapter 5 tells you how to adjust
apnea ventilation parameters. You are not required to review
apnea parameters before normal ventilation begins.
700 Series Ventilator Operator’s Manual 10066984 Rev. D 3-5
% O2
7-00067