Gas Turbine Handbook : Principles and Practices

Appendix D 405
“Vibration Analysis Of Cracked Turbine And Compressor Blades,” W.
Ostachowicz; M. Krawczuk. ASME 90-GT-005.
“Service Temperature Estimation Of Turbine Blades Based On Microstructural
Observations,” J.M. Aurrecoechea; W.D. Brentnall; J.R.
Gast. ASME 90-GT-023.
“Navier-Stokes Analysis Of Turbine Blade Heat Transfer,” R.J. Boyle.
ASME 90-GT-042.
“Detection Of A Rotating Stall Precursor In Isolated Axial Flow
Compressor Rotors,” M. Inoue; M. Kuroumaru; T. Iwamoto; Y. Ando.
ASME 90-GT-157.
“Combustor Exit Temperature Distortion Effects On Heat Transfer
And Aerodynamics Within A Rotating Turbine Blade Passage,” S.P.
Harasgama. ASME 90-GT-174.
“An Analytical Approach To Reliability Failure Forecasting And Product
Quality,” J.L. Byers. ASME 90-GT-190.
“Inlet Flow Distortion Effects On Rotating Stall,” J. Fortis; W.C. Moffatt.
ASME 90-GT-215.
“Enhanced On-Line Machinery Condition Monitoring Through Automated
Start-up/Shutdown Vibration Data Acquisition,” R.G. Harker;
G.W. Handelin. ASME 90-GT-272.
“Fault Detection And Diagnosis In Gas Turbines,” G. Herrington;
O.K. Kwon; G. Goodwin; B. Carlsson. ASME 90-GT-339.
“The Role For Expert Systems In Commercial Gas Turbine Engine
Monitoring,” D.L. Dundaas. ASME 90-GT-374.
“Gas Turbine Component Fault Identification By Means Of Adaptive
Performance Modeling,” A. Stamatis; K. Mathioudakis; M. Smith; K.
Papailiou. ASME 90-GT-376.
“Development Of Advanced Diagnostics For Turbine Disks,” J.R. Dunphy;
W.H. Atkinson. ASME 90-GT-390.