Gas Turbine Handbook : Principles and Practices

406 Gas Turbine Handbook: Principles and Practices
“Vibration Baseline, A Useful Concept For Condition Monitoring Of
Rotating Equipment,” J. Gorter; A.J. Klijn. ASME 85-GT-106.
“A Preliminary Assessment Of Compressor Fouling,” H.I.H. Saravanamuttoo;
A.N. Lakshminarasimha. ASME 85-GT-153.
LM1600 Gas Turbine Combustor Induced Vibration In Natural Gas
Transmission Pipeline Applications,” Barney Ong Industrial Applications
Of Gas Turbines 1993 Symposium October 13-15, 1993.
“Small Gas Turbine Generator Set Starting,” Colin Rogers. ASME
Cogen Turbo Power ’94.
“Analyzing Gas Turbine Failures To Identify Training Shortfalls,”
Lane Hunter Coward; James R. Hardin. ASME 96-GT-329.
“The Effects Of Environmental Contaminants On Industrial Gas
Turbine Thermal Barrier Coatings,” H.E. Eaton; N.S. Bornstein; J.T.
DeMarcin. ASME 96-GT-283.
“Capacitive Measurement Of Compressor And Turbine Blade Tip To
Casing Running Clearance,” D. Muller; S. Mozumdar; E. Johann,
A.G. Sheard. ASME 96-GT-349.
“Effects Of Inlet Distortion On The Flow Field In A Transonic Compressor
Rotor,” Chunill Hah; Douglas C. Rabe; Thomas J. Sullivan.
ASME 96-GT-547.
“Microwave Blade Tip Clearance Measurement System,” Richard
Grzybowski; George Foyt; William Atkinson; Hartwig Knoell. ASME
96-GT-002.
“Thermal Stresses In Gas Turbine Exhaust Duct Expansion Joints,”
Michael D. Ninacs; Rodney P. Bell. ASME 96-GT-398.
“Failure Analysis Of A Burner Component,” Kenneth L. Saunders;
Brian P. Copley. ASME 96-GT-399.
“Analytical Solution Of Whirl Speed And Mode Shape For Rotating
Shafts,” S.M. Young; G.J. Sheu; C.D. Yang. ASME 96-GT-264.