P12x/EN T/Eb6 - Schneider - error

Technical DataP12x/EN TD/Eb6MiCOM P120/P121/P122/P123 Page 15/509. PROTECTION SETTING RANGES9.1 [50/51] Phase Overcurrent (P120, P121, P122 & P123)− Phase current Fundamental onlyNOTE :When I> or I>> is associated to an IDMT curve, the maximum settingrecommended should be 2In.9.1.1 Protection Setting Ranges[51] Phase OCI> ? No or YesSetting RangeMin Max StepI> 0.1 In 25 In 0.01 InDelay typeDT or IDMT (IEC_STI, IEC_SI,IEC_VI, IEC_EI, IEC_LTI, C02, C08,IEEE_MI, IIEEE_VI, IEEE_EI, RI,RECT curve)tI> 0 s 150 s 0.01 sI> TMS 0.025 1.5 0.001I> Reset Delay Type DT or IDMTI> RTMS 0.025 1.5 0.001I> tReset 0.00 s 600 s 0.01 sK (RI) 0.1 10 0.1I> >> >>> interlock No or YesI>> ?No or YesI>> 0.5 In 40 In 0.01 InDelay typeDT or IDMT (IEC_STI, IEC_SI,IEC_VI, IEC_EI, IEC_LTI, C02, C08,IEEE_MI, IIEEE_VI, IEEE_EI, RI,RECT curve)tI>> 0 s 150 s 0.01 sI>> TMS 0.025 1.5 0.001I>> Reset Delay TypeDT or IDMTI>> RTMS 0.025 1.5 0.025I>> tReset 0.00 s 600 s 0.01 sK (RI) 0.1 10 0.1I>>> ?I>>> SampleNo or Yes or PeakNo or YesI>>> 0.5 In 40 In 0.01 IntI>>> 0 s 150 s 0.01 s9.2 [50N/51N] Earth fault protection (P121, P122 & P123)− Earth fault current Fundamental only− Earth fault current ranges See following tableNOTE :When Ie> or Ie>> are associated to an IDMT curve, the maximum settingrecommended should be the maximum of the range divided by 20.