P12x/EN T/Eb6 - Schneider - error

P12x/EN TD/Eb6Page 22/50Technical DataMiCOM P120/P121/P122/P12310.5 Logic select (P122 & P123)Logic selectivity 1 and logic selectivity 2: this function is used to assign each time delay tothreshold to the “Log Sel” input.Blocking InrushSel1 tI>>Sel1 tI>>>Sel1 tIe>>Sel1 tIe>>>Sel1 tIe>>>>Setting rangeMin Max StepYes or NoYes or NoYes or NoYes or NoYes or NoT Sel1 0s 500s 10ms10.6 Output relaysAlarm and trip threshold assignation to a logic output: 3 relays (P120, P121), 5 relays (P122)and 7 relays (P123).Assignable functions:−−−−all models: Output signal trip (RL1), I>, tI>, I>>, tI>>, I>>>, tI>>>, Ie>, tIe>, Ie>>, tIe>>,Ie>>>, tIe>>>, CB Close, Input 1 and input 2P121, P122 & P123 additional functions: t Aux 1, t Aux 2, Equation A, B, C, D, E, F, Gand H,P122 & P123 additional functions: Ie>>>>, tIe>>>>, tI, tI2>>, Therm., Therm.Trip , CB Alarm, 52 Fail, Brkn. Cond , CB Fail , t Aux 3, Order 1Comm. Order 2Comm,Order 3Comm., Order 4 Comm., Active Group, Input3, CTS,P123 additional functions: t Aux 4, t Aux 5, 79 Run, 79 Trip, 79 Locked, 79 Int block,79 Ext block, SOTF Group, CONTROL Trip, CONTROL Close, Input4, Input5, tIA>,tIB> and tIC>.10.7 Latch of the auxiliary output relays (P121, P122 & P123)Possibility to latch output relays:− P121: Output 2 to 4,− P122: Output 2 to 6,− P123: Output 2 to 8.10.8 Inputs10.8.1 Inputs assignationSingle function or multiple automation functions assignable to 4 logic inputs:− all models: None, Unlatch, 52 a, 52 b, CB FLT, Aux 1, Aux 2, Block Logic 1,−−P122 & P123 additional functions: Aux 3, Block Logic 2, Start Disturb, Cold Load PU,Logic Select 1, Logic Select 2, Change setting, θ Reset, Trip Circuit, Strt tBF, ResetLeds, Maint. Mode, Synchro, Ctrl Trip, Ctrl CloseP123 additional functions: Aux 3, Aux 4, Block [79], SOTF and local mode