P12x/EN T/Eb6 - Schneider - error

P12x/EN FT/Eb6Page 58/62HourDateOriginLengthTrip13:07:15:5312/11/01Ie>57 msNoUser GuideMiCOM P120/P121/P122/P123Displays the time when the instantaneous record wasrecorded. The format of the time is hh:mm:ss: ms.In this example the fault was recorded at 1:07:15 pm and530 ms.Displays the date when the instantaneous record wasrecorded. The format of the Date is DD/MM/YY. In thisexample, the fault was recorded on November 12th 2001.Displays which threshold has been crossed.Displays the period of time during which the thresholdhas been exceeded.Displays if a trip followed the crossing of the threshold or not.2.10.4 DISTURBANCE RECORD submenuThe Disturb Record submenu makes it possible to set and read disturbance records. Eachdisturbance record consists of analog and digital data. Up to 9 seconds disturbancerecord(s) duration can be stored (5 x 3s, 4 x 3s, 3 x 5s, 2 x 7s or 1 x 9s). The beginning ofthe record can be adjusted with a selected pre-time.RECORDDisturb RecordHeading of the Disturb Record submenu.Records number ?Pre-TimePost-Time50.2 s0.2 sDisturb Rec TrigON INST.Setting choices: 1, 2, 3, 4 or 5.Sets the disturbance record length. This setting choiceadjusts the number of records according to the recordlength. Setting choice allows 5 records of 3 seconds, 4records of 3 seconds, 3 records of 5 seconds, 2 records of7 seconds or 1 record of 9 seconds. (P122 and P123 only)Set the disturbance record pre-time, from 100ms to 3s (step100ms). The pre-time adjusts the beginning of thedisturbance record: In this example, the record starts 200msbefore the disturbance. Its length is fixed (except P120).P120 only: Set the disturbance record post-time, from100 ms to 3s (step 100ms). The total disturbancerecording time is 3 seconds (pre-time + post-time).Select which criteria will start the disturbance recordfunction. Setting choices are ON INST. (starts recordingon instantaneous thresholds) or ON TRIP (startsrecording after a trip happened).2.10.5 Time PEAK VALUE submenu (P122, P123 only)The Time PEAK VALUE submenu makes it possible to set parameters associated to thisfunction. (Peak and Average values displayed in the Measurements menu)RECORDTime Peak ValueHeading of the Time Peak Value submenu.Time Window5 mnSet the value for the time window during which peak andaverage values are stored, Select choice: 5mn, 10mn,15mn, 30mn, or 60mn.