P12x/EN T/Eb6 - Schneider - error

P12x/EN FT/Eb6Page 22/62Ie>>>>I1I2RATIO I2/I10.00A103A50A50%In - fnRST = [C] 0.0AThermal θRST = [C] 67%Max & Average IRST = [C]Max IL1 Rms127.36 AMax IL2 Rms156.28 AMax IL3 Rms139.01 AAverage IL1 Rms98.25 AAverage IL2 Rms97.88 AAverage IL3 Rms99.02 AMAX. SUBPERIODRST = [C]MAX. SUBPERIODIL1 Rms = 245AMAX. SUBPERIODIL2 Rms = 240AMAX. SUBPERIODIL3 Rms = 250AROLLING AVERAGERST = [C]ROLLING AVERAGEIL1 Rms = 0AROLLING AVERAGEIL2 Rms = 0AROLLING AVERAGEIL3 Rms = 0AUser GuideMiCOM P120/P121/P122/P123Displays the derived earth overcurrent threshold (1) .Displays the positive sequence component (1) .Displays the negative sequence component (1) .Displays the ratio of I2/I1. This derived measurement isused by the Broken Conductor detection function (menuAUTOMAT. CTRL) (1) .Displays the earth current In (True RMS value) minusthe current value at the fundamental frequency (value ofthe harmonics). Press to clear the value (passwordrequired) (1) .Displays the % thermal state based on true RMS values.Press to clear the % values (password required) (1) .Allows the user to clear the maximum (peak) andaverage (rolling) memorised values of the current.Press to clear these values (password required) (1) .Displays the peak value for phase A. The value is thetrue RMS maximum value (1) .As above for phase B (1) .As above for phase C (1) .Displays the rolling value for phase A. The value is thetrue RMS average value (1) .As above for phase B (1) .As above for phase C (1) .Allows the user to clear the maximum subperiod valuesof the 3 currents (1) .Displays the IA peak value demand. The value is thetrue RMS maximum value on a subperiod (1) .As above for IB peak (1) .As above for IC peak (1) .Allows the user to clear the rolling average values of the3 currents (1) .Displays the IA average value demand. The value is thetrue RMS average value on a number of subperiod set inRecord menu (1) .As above for IB average value (1) .As above for IC average value (1) .