P12x/EN T/Eb6 - Schneider - error

Hardware/Software VersionP12x/EN VC/Eb6History and CompatibilityMiCOM P120/P121/P122/P123 Page 19/34Relay Type P122SoftwareVersionDate ofIssueFull Description of Changes07.A 16/05/08 Software changes implemented in this version- Correction of the following defects:. temporisation IDMT of tReset (tI>> protection): ≠ 0safter tI>>,. fault record amplitude I2>> not displayed (front panel),. DMT temporisation ≥ 20s: decimal values truncated,. “Trip CB Fail” fault: type of fault not displayed,. SOTF: SOTF when current threshold is not selected,operation with I>> or I>>>with no possibility of reset,. CB supervision, Σamp:- measurement with 1 or 2 phases = 0A,- operation after a “CB Operation” sent by ModBus,. I2> and I2>> not updated when modified with ModBus,. the text for “SF6” alarm is incorrect,. parameters of DNP3 and ModBus addresses,. amplitude of K-Bus and Courier disturbancesextraction,. DNP3: events of major and minor hardware alarms,. the content of SRAM backup can be different ofcorresponding checksum after an update,. update of the phase indication of alarm tI>,. thermal protection:- calculation error when K thermal coefficient ≠ 1,- during cooling phase: bad delay between thermalalarm reset and thermal overflow.S1CompatibilityBackwardCompatibilitywith previoushardwareV2.14 HARD 3 orHARD 4,HARD 2.V10.E 29/08/06 v10.E software is equivalent to v6.J software basedon the phase II hardware redesign (HARD 5)V2.14 HARD 5Software changes implemented in this versionMultilanguage Human Machine Interface