P12x/EN T/Eb6 - Schneider - error

P12x/EN FT/Eb6Page 24/62User GuideMiCOM P120/P121/P122/P1232.7.2 Courier COMMUNICATION MenuCOMMUNICATIONHeading of the COMMUNICATION menu.Communication ?YesActivates Courier communication via the RS485 port onthe rear terminals of the relay.Relay Address12This cell sets the unique address for the relay such thatonly one relay is accessed by master station software.Select an address from 1 to 255.2.7.3 IEC 60870-5-103 COMMUNICATION MenuCOMMUNICATIONHeading of the COMMUNICATION menu.Communication ?YesData BitsRelay Address9600 bd29Activates IEC 60870-5-103 communication via theRS485 port on the rear terminals of the relay.Choose the baud rate of IEC 60870-5-103 transmission.Select from: 300, 600, 1200, 2400, 4800, 9600, 19200,38400 bauds.This cell sets the unique address for the relay such thatonly one relay is accessed by master station software.Select from 1 to 255 using . Press to validate yourchoice.2.7.4 DNP3 COMMUNICATION MenuCOMMUNICATIONHeading of the COMMUNICATION menu.Communication ?YesBaud RateParityStop BitsRelay Address9600 bdNone129Activates MODBUS RTU communication via the RS485port on the rear terminals of the relay.This cell controls the communication speed betweenrelay and master station.It is important that both relay and master station are setat the same speed setting.Select from: 300, 600, 1200, 2400, 4800, 9600, 19200,38400 bauds.Choose the parity in the MODBUS frame. Select Even,Odd or None.Choose the number of stop bits in the MODBUS frame.Select 0 or 1.This cell sets the unique address for the relay such thatonly one relay is accessed by master station software.Select from 1 to 255.