P12x/EN T/Eb6 - Schneider - error

User GuideP12x/EN FT/Eb6MiCOM P120/P121/P122/P123 Page 45/62CB CloseP122CB CloseP123Function P120 P121 P122 P123 INFORMATION and COMMENTSXXCircuit breaker closing order:“Ctrl Close” logic input, HMI, communicationfront face and rear port control of outputrelays (RL2 – RL5)Circuit breaker closing order:Only “autoreclose” function controls relaysRL2 to RL7 (see also “CONTROL close”function).t Aux 1 X X X Aux1 auxiliary input delayed by tAux1 time.t Aux 2 X X X Aux2 auxiliary input delayed by tAux2 time.t Aux 3 X X Aux3 auxiliary input delayed by tAux3 time.t Aux 4 X Aux4 auxiliary input delayed by tAux4 time.t Aux 5 X Aux5 auxiliary input delayed by tAux5 time.79 Run X Signal that Autoreclose cycle is working("Autorecloser in progress" signal).79 Trip X Autoreclose final trip function.79 Int block X Autoreclose lock activated by the internalprocess of the autoreclose79 Ext block X Autoreclose lock activated by the input “block79”Order 1Comm. X X Remote command 1Order 2Comm. X X Remote command 2.Order 3Comm. X X Remote command 3.Order 4 Comm. X X Remote command 4.Active Group X X Active Group indication.SOTF X SOTF functionality – when the tSOTF haselapsed the assigned relay is activated.CONTROL Trip X Control trip command.CONTROL Close X Control close command. Logic input, HMI,communication front face and rear portcontrol the affected relay (1 to 8). Refer to“CB Close (P123)” function to seeautoreclose control operation.Input1 X X X X Opto input 1.Input2 X X X X Opto input 2.Input3 X X Opto input 3 status.Input4 X Opto input 4 status.Input5 X Opto input 5 status.tIA> X First delayed threshold for phase A (tIA>)tIB> X First delayed threshold for phase B (tIB>).tIC> X First delayed threshold for phase C (tCI>).EQU. A X X X Logic output of Boolean Equation A.EQU. B X X X Logic output of Boolean Equation B.EQU. C X X X Logic output of Boolean Equation C.EQU D X X X Logic output of Boolean Equation D.