P12x/EN T/Eb6 - Schneider - error

User GuideP12x/EN FT/Eb6MiCOM P120/P121/P122/P123 Page 47/62NOTE:To reset the latched auxiliary relays:The auxiliary output latchedcan be reset by:2.9.8 Inputs submenuP121- Either by resetting of the"OPPARAMETERS/RelayStatus" from the frontpanel by pushing .- or by a logic inputassigned to this function- or by remote command.Note: No alarm dedicated tothe latch of the auxiliaryoutput relayP122 &P123- Either by resetting of thealarm "LATCH RELAYTRIP" from the front panelby pushing .- or by a logic inputassigned to this function- or by remote command.Note: The alarm "LATCHRELAY TRIP" is dedicated tothe latch of RL1This submenu makes it possible to assign a single function or multiple automation functionsto each logic input. The following functions are available for mapping to a logic input:Label P120 P121 P122 P123 FunctionNone X X X X No link/assignmentUnlatch X X X X Unlocks latched output relays52 a X X X X Position of the circuit breaker (open)52 b X X X X Position of the circuit breaker (close)CB FLT X X X X External failure information from the CBAux 1 X X X X Assign external information to input Aux1Aux 2 X X X X Assign external information to input Aux2Aux 3 X X Assign the input the external information Aux 3Aux 4 X Assign the input the external information Aux 4Aux 5 X Assign the input the external information Aux 5Block Logic 1Or Blk Log 1X X X X Blocking logic 1Block Logic 2 X X Blocking logic 2Start Disturb X X Starting of the disturbance recording functionCold LoadPULogic Select1Logic Select2ChangesettingX X Assign cold load pick upX X Logic selectivity 1X X Logic selectivity 2X X Change of setting group (default setting group1)Block [79] X Blocking of the autorecloser function [79]θ Reset X X Reset of the thermal stateTrip Circuit X X Trip circuit supervision inputStrt tBF X X Starting of the Breaker Fail TimerReset Leds X X Reset of the "Trip" & "Alarm" leds