Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationCommentParameterEntry StatusSpecifies a note for the device administrator.DescriptionUsed to enable or disable the DHCP server functionality over the interface.3. To enable DHCP Server, select Enable for DHCP Server Status. Before enabling, in interface table there should be atleast one interface enabled on which the DHCP Server has to run and the DHCP server pool table should have at leastone entry configured for that interface.4. In the Max Lease Time field, enter the maximum lease time.ParameterDHCP StatusMax Lease TimeDescriptionThis parameter is used to enable DHCP Server or disable the DHCP functionality on thedevice.Specifies the maximum lease time for which the DHCP client can have the IP addressprovided by the Server. The value ranges from 3600-86400 seconds.5. Click OK.6. To apply the configured properties of the device, click COMMIT.NOTE: For DHCP Server to be enabled on an interface, at least one address pool must be configured for that interface.4.9.1.1 DHCP PoolTo configure DHCP Pool1. Click ADVANCED CONFIGURATION > DHCP > DHCP Server > Pool. The DHCP Pool screen appears as shownbelow.Figure 4-62 DHCP PoolInterfaceParameterStart IP Address/EndIP AddressDeleteDescriptionSpecifies the interface to which the pool belongs.Specifies the start and end IP Address of the pool.Allows the user to delete the added pool entry.NOTE: Up to 5 entries per interface can be added in the IP Pool Table. A pool entry can be deleted but cannot beedited.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 100