Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationParameterDescriptionEthernet Protocol Filter TableProtocol NameProtocol NumberFilter StatusSpecifies the name of the Ethernet Protocol.Specifies the value of the Ethernet Protocol. The value is of 4 digit Hex format.This parameter allows configuring the Filter Status as either Block or Passthru. Thedefault is Block. Selection of the Filter Status takes effect only if the Entry Status isEnabled.When this filter status is set to Passthru and entry status is Enable, all packets whoseprotocol matches with the given protocol number are forwarded on the selected interface.When this filter status is set to Block and entry status is Enable, all packets whose protocolmatches with the given protocol number are dropped on selected interface.Entry StatusSet the Entry Status as Enable/Disable/Delete.NOTE: Click COMMIT for the changes to take effect in the device.3. A few frequently used filters are listed in the Ethernet Protocol Filter Table.4. For adding new entries to the Protocol filter Table:a. Click Add to display the Protocol Filters Add Row page as shown in the following figure.b. Enter the details as described in the preceding table and click Add.NOTES:Figure 4-52 Protocol Filter Add Row• By default, the system generates 19 entries. You can Enable or Disable the default entries, but the Delete optionis not applicable for all the default 19 entries.• The added entry in the table can be enabled, disabled, or deleted based on user requirement.• Max Entries supported in Ethernet Protocol Filter Table are 64.4.8.2 Static MAC Address Filter4.8.2.1 OverviewThe Static MAC Address filter optimizes the performance of a wireless and wired network. When this feature is configured,the device can block traffic between wired and wireless network based on MAC address.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 90