Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationFigure 4-71 NAT Port Bind Table Add RowTo add entries in the NAT static port bind table,1. Enter the Local IP Address of the host on the Ethernet (private) side of the End Point B.2. Select the Port Type as: TCP, UDP, or Both.3. Enter the Start Port, End Port and enable the Entry Status.4. Click Add.5. After adding the entry into the Static Port Bind Table, click COMMIT and then click REBOOT for the changes to takeeffect.4.11.2.1 Supported Session ProtocolsCertain applications require an Application Level Gateway (ALG) to provide the required transparency for an applicationrunning on a host in a private network to connect to its counterpart running on a host in the public network. An ALG mayinteract with NAT to set up state information, use NAT state information, modify application-specific payload, and performthe tasks necessary to get the application running across address realms.No more than one server of a particular type is supported within the private network behind the End Point B. Following is thelist of supported protocols with their corresponding default ALG's:S.No. Protocol Support Applications1 H.323 H.323 ALG Multimedia Conferencing2 HTTP Port Mapping forinbound connection3 TFTP Port Mapping forinbound connection4 Telnet Port Mapping forinbound connection5 IRC Port Mapping forinbound connection6 AMANDA Port Mapping forinbound connectionWeb BrowserTrivial file transferRemote loginChat and file transferBackup and archiving7 FTP FTP ALG File TransferTsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 107