Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced Configuration2. Enter the appropriate parameters in the IGMP Snooping Table. See the following table that lists the parameters and theirdescriptions.3.Click OK. To apply the changes, click COMMIT.ParameterIGMP SnoopingStatusIGMP MembershipAging TimerIGMP Router PortAging TimerIGMP Forced FloodDescriptionThis parameter is used to Enable/Disable the IGMP Snooping feature for the device. Thisfeature is supported only in bridge mode. By default, IGMP Snooping Status is disabled.This parameter represents the time after which the IGMP multicast group age-outs orelapses. It ranges from 135 to 635 sec. The default IGMP Membership Aging Timer is 260sec.This parameter represents the time after which the IGMP router port age-outs or elapses. Itranges from 260 to 635 sec. The default IGMP Router Port Aging Timer is 300 sec.If you select Yes, all the Unregistered IPv4 multicast traffic (with destination address whichdoes not match any of the groups announced in earlier IGMP Membership reports) andIGMP Membership Reports will be flooded to all the ports. By default, IGMP Forced Flood isset to No.4.11 Routing Features Configuration4.11.1 Static Route Table (Routing Mode Only)The static routing table mechanism is available for End Point A and End Point B in routing mode only. It stores the route tovarious destinations on the network. When packets are to be routed, the routing table is referred to for the destinationaddress.Figure 4-68 Netlp Static Route TableTo set the static routing table1. Click ADVANCED CONFIGURATION > Network > Static Route Table.2. Enter the appropriate parameters. See the following table that lists the parameters and their descriptions.3. Click Add to add a new entry in the table.ParameterStatic Route StatusDescriptionThis parameter is used to enable or disable the Static Route Status. This parameter isapplicable to all static routes.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 104