Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationParameterServer TypeIP AddressServer PortShared SecretEntry StatusThis is a read only parameter and displays the server type. Two Server Types are supported:Primary Auth Server and Secondary Auth Server.Enter the Server’s IP address.DescriptionSpecifies the port number which is used by the unit and the Radius server to communicate.By default, RADIUS AuthenticationServer communicates on port 1812.Specifies the password shared by the RADIUS server and the QB-8100 device. The defaultpassword is public.Select Enable/Disable to enable or disable the RADIUS server status.Following constraints apply for Radius Profile configuration:1. Message Response Time should always be less than WORP Registration Timeout parameter value.2. If Max Retransmissions is configured as Zero, retransmissions do not occur.3. The value of Max Retransmissions multiplied by Message Response Time should be less than WORPRegistration Timeout value.4. Max Retransmission Valid Range is 0 to 3.5. Message Response Time Valid Range is 3 to 9.NOTE: RADIUS authentication configuration is applicable only for End Point A.4.5.3 Configuring the MAC ACL (End Point A Only)You can control the access to the network using MAC Access Control List (ACL). MAC ACL is available only on End Point A.MAC Authentication is supported on the wireless interface only (not supported for the devices on the Ethernet side) and onlyEnd Point B wireless MAC addresses should be added to the list. The MAC ACL is referred to only when it is enabled on theWORP Configuration page.To configure the MAC ACL1. Click ADVANCED CONFIGURATION > Security > MAC ACL. The MAC Access Control screen is displayed as shownbelow.2. Select the Operation Type as either Allow or Deny.Figure 4-17 MAC Access ControlTsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 59