Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced Configuration4.1 System ConfigurationThe System feature enables you to configure system specific information.To configure the System parameters do the following:1. Click ADVANCED CONFIGURATION > System. The System screen is displayed as shown below:Figure 4-1 System screen2. From the Radio Mode drop-down menu, select either End Point A or End Point B.3. From the Frequency Domain drop-down menu, select a frequency domain.4. From the Network Mode drop-down menu, select either Bridge or Routing.5. For the Maximum MTU field, enter the maximum MTU value.6. Click OK.The following table lists the System parameters and their descriptions:ParameterRadio ModeFrequency DomainNetwork ModeActive Network ModeDescriptionRadio mode specifies the mode of operation and the device supports two types of modes,End Point A and End Point B.A valid frequency domain must be set before the device can be configured with any otherparameters. Selecting a frequency domain makes the device compliant with the allowedfrequency bands and channels for that regulatory domain.The device can be configured in two network modes: Bridge Mode and Routing Mode. Thedefault network mode is Bridge Mode.Refer to Configuring IP in Bridge or Router Mode for more information.This is a read-only parameter which shows current operating network mode of the device.It is displayed only when the newly configured Network mode differs from the currentActive Network mode.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 37