Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationParameterOperational Tx ModeTxMode And SpeedDescriptionDisplays the current operational transmit mode of the Ethernet interface. There are 2 typesof transmission modes:• Half Duplex: Allows one-way transmission at a time. Only receive or transmitoperations can be performed at once.• Full Duplex: Allows two-way transmissions simultaneously.This parameter allows the user to select the speed and mode based on the requirement forthe corresponding interface.NOTES:• Auto: Selects the best transmission mode available when both sides are set toAuto.• The recommended setting is Auto.• In order to allow communication, the transmitter and receiver should beconfigured in same transmission modes.• The maximum speed is measured as 100 megabits per second.Admin StatusThis parameter is enabled by default for an ethernet interface.4.4 Wireless ConfigurationThe Tsunami QB-8100 series of devices use a proprietary Wireless Outdoor Router Protocol (WORP). WORP offers servicesbased on a polling algorithm, specially designed for wireless outdoor networks. WORP is designed to minimize the number ofpackets being sent over the air by incorporating several mechanisms, like super-packeting and piggy-back acknowledgmentin order to achieve maximum throughput possible in the outdoor conditions.A WORP-based device provides two modes of operations for establishing a wireless link, End Point A and End Point B. Basedon the mode of operation at the interface, the respective parameters can be configured. The following sections describe theconfigurations for End Point A and End Point B.4.4.1 Configuring WORP Properties in End Point A ModeTo set the WORP properties1. Click Advanced Configuration > Wireless > Interface1 > WORP. The WORP Configuration screen appears.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 41