Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationFigure 4-50 Filtering2. Enter the appropriate parameters in the Filtering screen. See the following table that lists all the parameters and theirdescriptions.ParameterGlobal Filter FlagSTP/LACP FramesDescriptionThis parameter is used to enable or disable complete filtering operations.This parameter is used to Block or Allow STP/LACP frames. By default, the STP/LACPframes are blocked.STP/LACP Frame Status will block/passthru the frames destined to IEEE 802.1D and 802.1Qreserved MAC address (01:80:C2:00:00:00 to 01:80:C2:00:00:0F).3. Click OK.NOTES:• The filtering process is activated only when the Global Filter Flag is selected as Enable.• Click COMMIT for the changes to take effect in the device.4.8.1 Ethernet Protocol FilterThe Ethernet Protocol Filter blocks or forwards packets based on the Ethernet protocols supported on the device. The filteringtakes effect only when the Global Flag is enabled.The packets are forwarded or dropped depending on their Entry status, Filter status and Filtering Type.To configure Ethernet Protocol Filtering,1. Click ADVANCED CONFIGURATION > Filtering > Ethernet Protocol Filtering. The Protocol Filter screen isdisplayed as shown below.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 88