Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

System Management5.1 System5.1.1 System InformationThis section displays the basic system information. This information further helps in viewing the device details duringtroubleshooting. For configuring the system information, click MANAGEMENT > System > Information.Figure 5-1 System InformationParameterSystem Up-TimeSystem DescriptionSystem NameEmailPhone NumberLocationGPS Longitude, GPSLatitude and GPSAltitudeDescriptionSpecifies the duration of the device running time, since its last reboot.Specifies the description of the system. It reports the device name, current firmware andbuild number.Specifies the system name for easy identification of End Point A or End Point B. TheSystem Name parameter is limited to a length of 64 characters. Use the System Name ofan End Point A to configure the End Point A Name parameter on an End Point B if youwant the End Point B to register only with this End Point A. If the End Point A Name is leftblank on the End Point B, it can register with any End Point A that has a matching NetworkName and Network Secret.Specifies the Email address of the concerned person responsible for the device.Specifies the Phone number of the concerned person responsible for the device.Specifies the location of the device.Specifies the GPS longitude, latitude and altitude at which the device is installed.After setting the system information, click COMMIT for the changes to take effect in the device.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 111