Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationAdding New Trunk Table EntriesTo add new table entries1. Click Add in the VLAN Ethernet Configuration screen. The VLAN Trunk Table Add Row page appears.Figure 4-48 VLAN Trunk Table Add Row2. Enter the parameters as described in the following table.3. Click Add.FieldDescriptionTrunk IdEntry StatusEnter the value of the trunk VLAN Id.Enable or disable the status of the trunktable entry.4. Click COMMIT for the changes to take effect.NOTE: Up to 256 VLAN IDs can be configured on the Ethernet interfaces.4.7.2.3 Access ModeAccess mode is available only on the Ethernet interface of End Point B. This mode is used to connect VLAN aware networkswith VLAN unaware networks. In access mode, Tagged frames with specified Access Vlan ID going out of the device throughthe Ethernet interface are untagged and forwarded. The untagged frames coming into the device through the Ethernetinterface are tagged with specified Access Vlan ID and Access Vlan priority and forwarded.NOTE: When the device is configured in Access Mode, the device can be managed from the ethernet side using taggedpackets containing Management VLAN ID which is not equal to (Different) Access VLAN ID. This helps the fieldengineer to use a VLAN capable laptop to connect to the ethernet interface of the device and modify theconfiguration.To configure the Access Mode in the VLAN network1. Click ADVANCED CONFIGURATION > VLAN > Ethernet. The VLAN Ethernet Configuration screen appears.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 86