Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationFigure 4-57 TCP/UDP Port Filter2. Enter the appropriate parameters. See the following table that lists the parameters and their descriptions.ParameterFilter ControlProtocol NamePort NumberPort TypeFilter InterfaceEntry StatusDescriptionThis parameter is used to enable the TCP/UDP filter. By default, Disable is selected.This parameter specifies the TCP/UDP protocol filter name.This parameter specifies the TCP/UDP port number. It accepts the values within the range0-65535.This parameter specifies the type of the port. The various options for the Port Type are TCP,UDP and Both. By default, Port Type is Both for the default entries and TCP for the newlyadded entries.This parameter is used to configure the interface type. Options for filter interface areEthernet, Wireless, and All Interfaces.This parameter indicates the status of TCP/UDP filter entry.Enable: The device filters the TCP/UDP protocolsDisable: The device allows all the TCP/UDP protocols.4.8.4.1 Adding TCP/UDP Port Table EntriesTo add TCP/UDP Port Table entries1. Click Add to create a new TCP/UDP port filter. The TCP/UDP Port Filter Add Row page is displayed as shown below.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 96