Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)
Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)
Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Advanced ConfigurationVLAN parameters can be classified into two types: System-related VLAN parameters and Interface-related VLAN parameters.1. System-related parameters: These parameters are applicable to the whole device. The following parameters are theSystem-related VLAN parameters.a. VLAN Status: Selecting the VLAN Status checkbox enables the VLAN Status on the device. To update all VLANrelated parameters, VLAN status should be enabled.NOTE: By default, the VLAN status is disabled.b. Management VLAN ID: This parameter is used to configure the Management VLAN ID. This option is availablewhen Management VLAN ID is configured. The management stations must tag the management frames sent tothe device with the management VLAN ID specified in the device. The device will tag all the management framesfrom the device with the specified management VLAN and priority.NOTES:• If the Management VLAN ID is -1, only untagged frames can access the device.• Before setting the Management VLAN ID from 1 to 4094, make sure that the management platform or host is amember of the same VLAN; or else, your access to the device will be lost.c. Management VLAN Priority: This parameter is used to set IEEE 802.1p priority for the frames. The priority valueranges from 0 to 7. By default, it is set to 0 (zero).2. Interface-related VLAN parameters: The device supports configuring VLAN modes for Ethernet interface. Thewireless interface is always in Transparent Mode.4.7.2 VLAN Modes4.7.2.1 Transparent ModeTransparent Mode is available for the Ethernet and Wireless interfaces for both End Point A and End Point B. It is equivalent toNO VLAN support and is the default mode. It is used to connect VLAN aware / unaware networks. An interface intransparent mode forwards both tagged and untagged frames.To configure the VLAN Transparent Mode1. Click ADVANCED CONFIGURATION > VLAN > Ethernet. The VLAN Ethernet Configuration window appears asshown below.2. Enter the parameters listed in the following table.Figure 4-46 VLAN Operation in Transparent ModeTsunami <strong>QB</strong>-<strong>8100</strong> <strong>Series</strong> (<strong>50</strong> <strong>Mbps</strong> / <strong>12</strong> <strong>Mbps</strong>) Installation and Management Guide 84
Change language