Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

System ManagementParameterDescriptionHTTPSelect Enable to allow HTTP access to the device from any host. You can also selectDisable to prevent access to the device from Web interface. Similar settings are applicablefor Hypertext Transfer Protocol over Secure Socket Layer or HTTPS.HTTP Port Specifies the port number for HTTP interface. By default, the port number is 80.HTTPSSimilar settings as mentioned for HTTP. The password configuration for HTTPS is same asconfigured for HTTP.5.3.2 Telnet/SSHFigure 5-12 Telnet/SSHThe parameters for Telnet/SSH are described in the following table.Telnet/SSH Parameter settingsPasswordTelnetSet a new password for the interface or interfaces to manage the device through the CLI.The same password is used for serial CLI also.Select Enable to allow the Telnet access to the device from any host. You can also selectDisable to prevent a user from accessing the device from the CLI. Similar settings areapplicable for Secure Shell or SSH.Telnet Port Specifies the port number for Telnet interface. By default, the port number is 23.Telnet SessionsSSHSpecifies the number of Telnet sessions which controls the number of active Telnetconnections. By default, the number of telnet sessions allowed is 2.Select Enable to enable SSH access to the device from any host or select Disable toprevent a user from accessing the device.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 119