Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

More documents

Recommendations

Info

Advanced ConfigurationNOTE: Based on the Operation Type, the user can allow or deny the association of the MAC ACL profile to an EndPoint B.3. Click OK.To add entries to MAC Access Control table,Figure 4-18 MAC ACL Add Row1. Click Add in the MAC Access Control screen. The MAC ACL Add Row page appears.2. Enter the MAC Address and Comment, and then select Enable/Disable to enable or disable Entry Status of theMAC Address.3. Click Add.NOTES:• MAC Access Control authentication is available only for End Point A.• The maximum number of MAC addresses that can be added to this table is 250.• MAC ACL Status and Radius MAC ACL Status fields cannot be enabled simultaneously.4.6 Quality of Service (QoS) ConfigurationThe Quality of Service (QoS) feature is based on the 802.16 standard and defines the classes, service flows, and packetidentification rules for specific types of traffic.4.6.1 QoS Concepts and DefinitionsThe software supports QoS provisioning from the End Point A only. You may define different classes of service on a End PointA that can then be assigned to the End Point B that is associated, or that may get associated, with that End Point A.You can create, edit, and delete classes of service that are specified by the following hierarchy of parameters:• Packet Identification Rule (PIR) – up to 64 rules, including 18 predefined rules• Service Flow class (SFC) – up to 32 SFCs, including 8 predefined SFCs; up to 8 PIRs may be associated per SFC• Priority for each rule within each SF class – 0 to 255, with 0 being lowest priority• QoS class – up to 8 QoS classes, including 5 predefined classes; up to 8 SFCs may be associated per QoS class4.6.1.1 Packet Identification Rule (PIR)A Packet Identification Rule is a combination of parameters that specifies what type of traffic is allowed or disallowed. Youcan create up to 64 different PIRs, including 18 predefined PIRs. Also, you can create, edit, and delete PIRs that contain none,one, or more of the following classification fields:• Rule Name• IP ToS (Layer 3 QoS identification)Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 60
Advanced Configuration• 802.1p tag (layer 2 QoS identification)• IP Protocol List containing up to 4 IP protocols• VLAN ID• PPPoE Encapsulation• Ether Type (Ethernet Protocol identification)• Up to 4 TCP/UDP Source port ranges• Up to 4 TCP/UDP Destination port ranges• Up to 4 pairs of Source IP address + Mask• Up to 4 pairs of Destination IP address + Mask• Up to 4 source MAC addresses + Mask• Up to 4 destination MAC addresses + MaskNOTE: IP Address, TCP/UDP Port, MAC Address need to be configured separately and associate those classification inPIR details if required.A good example is provided by the 18 predefined PIRs. Note that these rules help identify specific traffic types:1. All – No classification fields, all traffic matches2. L2 Multicasta. Ethernet Destination (dest = 0x010000000000, mask = 0x010000000000)3. L2 Broadcasta. Ethernet Destination (dest = 0xffffffffffff, mask = 0xffffffffffff)4. Cisco VoIP ULa. TCP/UDP Source Port Range (16,000-33,000)b. IP Protocol List (17 = UDP)5. Vonage VoIP ULa. TCP/UDP Source Port Range (5060-5061, 10000-20000)b. IP Protocol List (17 = UDP)6. Cisco VoIP DLa. TCP/UDP Destination Port Range (16,000-33,000)b. IP Protocol List (17 = UDP)7. Vonage VoIP DLa. TCP/UDP Destination Port Range (5060-5061, 10000-20000)b. IP Protocol List (17 = UDP)8. TCPa. IP Protocol List (6)9. UDPa. IP Protocol List (17)10. PPPoE Controla. Ether Type Rule (Ether Type = DIX-Snap, Ether Value = 0x8863)11. PPPoE Dataa. Ether Type Rule (Ether Type = DIX-Snap, Ether Value = 0x8864)12. IPa. Ether Type Rule (Ether Type = DIX-Snap, Ether Value = 0x0800)13. ARPTsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 61
Page 1:
Tsunami QB-8100 Series (50 Mbps / 1
Page 6 and 7:
Event Log . . . . . . . . . . . . .
Page 8 and 9:
PrefacePrefaceAbout this ManualCong
Page 10 and 11: Overview1.1 IntroductionProxim’s
Page 12 and 13: OverviewNetwork Manager program usi
Page 14 and 15: Installation and Initialization2.1.
Page 16 and 17: Installation and InitializationWhat
Page 18 and 19: Installation and Initialization2. M
Page 20 and 21: Installation and InitializationFigu
Page 22 and 23: Installation and InitializationUsin
Page 24 and 25: Installation and InitializationThe
Page 26 and 27: Installation and InitializationFigu
Page 28 and 29: Basic Configuration3This chapter co
Page 30 and 31: Basic ConfigurationIf ACS is disabl
Page 32 and 33: Basic Configuration3.7 Basic Config
Page 34 and 35: Basic ConfigurationPreferred Channe
Page 36 and 37: Advanced Configuration4This chapter
Page 38 and 39: Advanced ConfigurationParameterMaxi
Page 40 and 41: Advanced ConfigurationParameterDesc
Page 42 and 43: Advanced ConfigurationFigure 4-6 WO
Page 44 and 45: Advanced ConfigurationParameterMAC
Page 46 and 47: Advanced ConfigurationParameterSate
Page 48 and 49: Advanced Configuration4.4.6 MIMO Pr
Page 50 and 51: Advanced ConfigurationIf ACS is dis
Page 52 and 53: Advanced Configuration4.4.7.3 Black
Page 54 and 55: Advanced ConfigurationMaximum RateT
Page 56 and 57: Advanced ConfigurationFigure 4-13 W
Page 58 and 59: Advanced Configuration1. Click ADVA
Page 62 and 63: Advanced Configurationa. Ether Type
Page 64 and 65: Advanced Configuration• Service F
Page 66 and 67: Advanced ConfigurationFigure 4-21 Q
Page 70 and 71: Advanced ConfigurationParameterRule
Page 76 and 77: Advanced Configuration4.6.2.3 QoS C
Page 80 and 81: Advanced Configuration4.6.3 QoS Con
Page 82 and 83: Advanced Configuration• Traffic D
Page 84 and 85: Advanced ConfigurationVLAN paramete
Page 86 and 87: Advanced ConfigurationAdding New Tr
Page 88 and 89: Advanced ConfigurationFigure 4-50 F
Page 90 and 91: Advanced ConfigurationParameterDesc
Page 92 and 93: Advanced ConfigurationResult: When
Page 94 and 95: Advanced ConfigurationFigure 4-55 A
Page 96 and 97: Advanced ConfigurationFigure 4-57 T
Page 98 and 99: Advanced ConfigurationParameterInte
Page 100 and 101: Advanced ConfigurationCommentParame
Page 102 and 103: Advanced ConfigurationFigure 4-65 D
Page 104 and 105: Advanced Configuration2. Enter the
Page 106 and 107: Advanced Configuration1. Static NAT
Page 108 and 109: Advanced ConfigurationS.No. Protoco
Page 110 and 111:
System Management5This chapter prov
Page 112 and 113:
System Management5.1.2 Identifying
Page 114 and 115:
System ManagementFigure 5-4 HTTP Up
Page 116 and 117:
System ManagementFigure 5-7 Upgrade
Page 118 and 119:
System Management3. Select the type
Page 120 and 121:
System ManagementSSH PortSSH Sessio
Page 122 and 123:
System ManagementPriv ProtocolPriv
Page 124 and 125:
System ManagementParameterDescripti
Page 126 and 127:
System ManagementFigure 5-20 Manage
Page 128 and 129:
Monitoring the System6.1 Interface
Page 130 and 131:
Monitoring the SystemParameterCRC E
Page 132 and 133:
Monitoring the SystemFieldSend Fail
Page 134 and 135:
Monitoring the SystemFieldDescripti
Page 136 and 137:
Monitoring the System6.3 Bridge6.3.
Page 138 and 139:
Monitoring the System6.4 Network La
Page 140 and 141:
Monitoring the SystemFieldIn Timest
Page 142 and 143:
Monitoring the System6.6 IGMP (Brid
Page 144 and 145:
Monitoring the SystemFigure 6-17 Ev
Page 146 and 147:
Monitoring the SystemFigure 6-20 WO
Page 148 and 149:
Procedures7This chapter provides de
Page 150 and 151:
Procedures7.3 Configuration BackupY
Page 152 and 153:
ProceduresFigure 7-1 HTTP Retrieve
Page 154 and 155:
Procedures• Remove unchanged conf
Page 156 and 157:
Proceduresdefault or modified or ad
Page 158 and 159:
Troubleshooting8.1 PoE Injector8.1.
Page 160 and 161:
Troubleshooting4. If you are using
Page 162 and 163:
TroubleshootingSystem Name(config-n
Page 164 and 165:
Troubleshooting8.4.8 Changes Do Not
Page 166 and 167:
Frequency Domains and ChannelsAIntr
Page 168 and 169:
Frequency Domains and Channels5 GHz
Page 170 and 171:
Frequency Domains and ChannelsFrequ
Page 172 and 173:
Boot Loader CLI and ScanToolTo Load
Page 174 and 175:
Technical SpecificationsPart Number
Page 176 and 177:
Technical SpecificationsIntegrated
Page 178 and 179:
Technical SpecificationsTransmit Po
Page 180 and 181:
Technical SpecificationsCategorySpe
Page 182 and 183:
Technical SpecificationsPhysical an
Page 184 and 185:
Parameters Requiring RebootETabulat
Page 186 and 187:
Statement of WarrantyFWarranty Cove
Page 188 and 189:
Technical Services and SupportGObta
Page 190:
Technical Services and SupportServP
show all

Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Create successful ePaper yourself

Delete template?

Save as template?