Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Monitoring the SystemFieldDescriptionRemote Tx Rate(Mbps)Local Antenna PortInfoEnd Point B Tx Rate.Refers to the status of the local antenna port for the End Point B. This status is shown bythree different legends:This legend is displayed when the antennaport is disabled.This legend is displayed when the antennaport is enabled and signal is present.This legend is displayed when the antennaport is enabled and signal is not present.Local Signal (dBm)Local SNR (dB)Remote Antenna PortInfoRefers to the signal level with which the End Point A received wireless frames from the EndPoint B.Refers to the SNR measured by the receiver at the near end and is based on the Local Signaland Local Noise.Refers to the status of the remote antenna port of the End Point B. The status of theremote antenna port is shown by three different legends. For more information on thelegends, refer to Local Antenna Port Info.Remote Signal (dBm) Signal level with which the End Point B receives wireless frames from the End Point A.Remote SNR (dB)MIMO Chain BalanceRefers to the SNR measured by the receiver at the far end and is based on the RemoteSignal and Remote Noise.Refers to the signal balance between minimum 2 Rx chains. If the signal balance betweentwo antennas is greater than 5 dB, then, it is recommended to adjust the antennas so thatMIMO Chain Balance becomes Balanced or switch to Longer Range Data Stream settingsfor reliable wireless link.NOTE: This field is applicable only for Higher Throughput data streams.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 134