13.07.2015 Views

Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Advanced ConfigurationParameterDestination AddressRoute MaskRoute Next HopMetricEntry StatusDescriptionSpecifies the destination IP address for which the static route is to be made.Specifies the subnet mask of the destination IP address.Specifies the next hop IP Address through which route is available to the destination IPaddress. Next hop IP should belong to at least one of the subnets connected to the device.It is a metric that specifies the distance to the target usually counted in hops. The priority isgiven to this route relative to others. It can range from 0 – 16.This parameter is used to configure the status of the static route. Only enabled routes areconsidered for routing the packets.4.11.1.1 Adding Static Route EntriesTo add Static Route entries1. Click Add in the Static Route Table screen. The Static Route Table Add Row screen is displayed as shown below.Figure 4-69 Static Route Table Add Row2. After adding the entry into the Static Route table, click Add.3. Click COMMIT for the changes to take effect.NOTES:• Maximum 256 entries can be added to the static route table.• While adding a new entry, the IP address of the Next Hop must be on the subnet of one of the device’s networkinterfaces.4.11.2 NAT (End Point B, Routing Mode Only)The NAT (Network Address Translation) feature allows hosts on the Ethernet side of the End Point B to transparently accessthe public network through the End Point A. All the hosts in the private network can have simultaneous access to the publicnetwork.The End Point B supports NAPT (Network Address Port Translation) where all private IP addresses are mapped to a singlepublic IP address and does not support Basic NAT (where private IP addresses are mapped to a pool of public IP addresses).Both dynamic mapping (allowing private hosts to access hosts in the public network) and static mapping (allowing publichosts to access hosts in the private network) are supported.Tsunami <strong>QB</strong>-<strong>8100</strong> <strong>Series</strong> (<strong>50</strong> <strong>Mbps</strong> / <strong>12</strong> <strong>Mbps</strong>) Installation and Management Guide 105

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!