Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationFor instructions on configuring a management station (a single station used for managing an entire network), refer to QoSConfiguration for a Management Station.QoS PIR MAC Address Configuration1. Click ADVANCED CONFIGURATION > QoS > PIR List > MAC Address Entries.2. Three predefined MAC Address entries are displayed in this page. You can configure maximum 256 entries. MACAddress and Mask combination should be unique. This MAC Address entry can be referred in the PIR Rule’s Source orDestination MAC Address Classification. MAC Entry referred by any PIR rule cannot be deleted.Figure 4-19 QoS PIR MAC Address Entries3. Add a New PIR MAC Address Entrya. Click Add to add a new entry. The following screen appears for configuring the MAC Entry Details.Figure 4-20 QoS PIR MAC Address Add Entryb. Provide the MAC Address, Mask, Comment, Entry Status details and click Add. Comment field can be used toidentify when this particular entry is referred in PIR Rule/QoS Class.QoS PIR IP Address Configuration1. Click ADVANCED CONFIGURATION > QoS > PIR List > IP Address Entries. A single predefined IP Address entry isdisplayed. You can configure maximum 256 entries. IP Address, Subnet Mask combination should be unique. This IPAddress entry can be referred in the PIR Rule’s Source or Destination IP Address Classification. IP Address Entry referredby any PIR rule cannot be deleted.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 65