Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced ConfigurationParameterDescriptionDefault Gateway IP AddressDefault Gateway IPAddressThis parameter represents the gateway IP Address of the device.In Bridge Mode: When the Address Type is selected as Dynamic, this parameterbecomes read-only and displays the device’s current gateway IP Address that is obtainedthrough DHCP. If the device cannot obtain an address from a DHCP server, the defaultgateway IP Address is 169.254.128.132. When Static IP assignment is used, subnet of thedefault gateway should match with the subnet of any one of the interfaces.DNSPrimary IP AddressSecondary IP AddressSpecifies the IP Address of the Primary DNS Server.Specifies the IP Address of the Secondary DNS Server.NOTE: Click COMMIT and then REBOOT for the changes to take effect.4.3 Ethernet Properties ConfigurationIn the Ethernet Interface Properties screen, you can configure the Ethernet transmission properties. The recommendedsettings are Auto for TxMode And Speed. The device supports a single ethernet interface Ethernet 1.To configure the Ethernet Interface1. Click ADVANCED CONFIGURATION > Ethernet. The Ethernet Interface Properties screen is displayed as shownbelow.Figure 4-5 Wireless Ethernet Properties2. Enter the appropriate parameters in the Ethernet Interface Properties screen. See the following table that lists theparameters and their descriptions.3. Click OK and then click COMMIT.ParameterMAC AddressOperational SpeedDescriptionDisplays the MAC address of the Ethernet interface.Displays the current operational speed of the Ethernet interface. The speed is 100 Mbps.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 40