Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Installation and InitializationFigure 2-8 Modifying the IP Address2.4.3.1 Assigning the IP Address Manually1. Select the IP Address Type as Static and then enter the appropriate IP Address, Subnet Mask, and the Gateway IPAddress parameters.2. Enter the SNMP Read/Write password in the Read/Write Password field. By default, it is public.3. Click OK to save the details.The device automatically reboots after clicking OK.Click Rescan to verify whether the changes are applied or not. Then, click Web Configuration to open the web interface.2.4.3.2 Assigning the IP Address DynamicallyTo change the IP Address type from Static to Dynamic, follow these steps:NOTE: Before setting the IP Address Type as Dynamic, ensure there is a DHCP server in the network.1. Select the IP Address Type as Dynamic. The IP Address, Subnet Mask and the Gateway IP Address fields getdisabled.2. Enter the SNMP Read/Write password in the Read/Write Password field. By default, it is public.3. Click OK to save the details.The device automatically reboots after clicking OK.Click Rescan to verify whether the changes are applied or not. Then, click Web Configuration to open the web interface.The user is then prompted to enter its username and password.2.5 Logging in to the Web InterfaceOnce the device is connected to your computer, use a web browser to configure and monitor the device. Enter the device IPaddress (For example, http://169.254.128.132) in the address bar.NOTE: You can also log on to the Web Interface using ScanToolTsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 23