Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced Configuration• Gateway IP address• Subnet Mask• Lease Time• DNS Primary Server IP address• DNS Secondary Server IP addressIn Routing mode, DHCP Server can be configured for each interface separately. Unless the DHCP Server functionality isenabled for an interface, the DHCP Server does not respond to the DHCP requests received on that interface.NOTE: The DHCP Server functionality is available in both Routing and Bridge Modes.To configure the DHCP server and DHCP Interface table1. Click ADVANCED Configuration > DHCP > DHCP Server > Interfaces. The DHCP screen appears as shown below.Figure 4-61 DHCP2. Enter the appropriate parameters in the DHCP Interface Table. See the following table that lists the parameters andtheir descriptions.NOTE: To enable the DHCP Server Interface, the DHCP server pool table should have at least one range configured forthat interface.ParameterInterface TypeNet MaskDefault GatewayPrimary DNSSecondary DNSDefault Lease TimeDescriptionSpecifies the interface for which the DHCP Server functionality shall be configured.Specifies the subnet mask to be sent to the client along with the assigned IP address. Thenetmask configured here should be greater than or equal to the netmask configured onthe interface.Specifies the default gateway to be sent to the client along with assigned IP Address.Default Gateway is a node that serves as an accessing point to another network.Specifies the primary DNS (Domain Name Server) IP address to be sent to the client.Specifies the secondary DNS IP address to be sent to the client.DHCP Server uses this option to specify the lease time it is willing to offer to the client overthat interface.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 99