Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Boot Loader CLI and ScanToolTo Load the Firmware from the Network• Use the show command to view the parameters and their values and use the set command to set the values to theparameters as per the requirement.To Get the IP Parameters Dynamically for Loading the Firmware1. Set the ipaddrtype to dynamic.2. Run the BOOTP and TFTP Servers along with a reboot of the unit.When the device reboots, the device gets the IP Address and Boot filename from the BOOTP server. You need not change anyof the above parameters. After BOOTP succeeds, the device initiates a TFTP request with the filename it gets from BOOTP.To Load the Firmware by Using Static IP Parameters1. Use the set command to set the IP parameters like ‘ipaddr’, ‘serverip’, ‘filename’ and also set the parameter‘ipaddrtype’ to static.2. Run the TFTP Server along with a reboot of the unit.When the device reboots, the TFTP request is initiated with the value taken from the parameter “filename”. This request issent to the IP address set to the parameter "serverip”. In this case, the TFTP Server should be reachable to the device.ScanToolIf you want to access the device with Scantool, then the host running the ScanTool should also be in the same network as thedevice. The ScanTool broadcast requests are discarded by the routers if the device and the host running the ScanTool are indifferent network. This means that the ScanTool cannot discover the device.A device in Boot Loader can be recognized by looking at the system description. If the system description does not containany build number in braces, conclude that the device is in Boot Loader mode.For example:Tsunami QB-8150-EPR-WDv2.3.4SN-10P145010023v1.0.0- Description of the device- Firmware Version- Serial Number- Bootloader versionFigure B-1 Scan Tool View of a Device in Boot Loader ModeTsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 172