Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Advanced Configuration3. Click OK.ParametersDescriptionInterfaceVLAN ModeDisplays the name of the interface.Select the VLAN mode as Transparent.Click COMMIT for the changes to take effect. Once the transparent mode is set, both tagged and untagged frames arereceived on the interface.NOTE: Wireless Interface of the device will always be in transparent mode. There is no support provided to edit thewireless interface VLAN parameters.4.7.2.2 Trunk ModeTrunk mode is configurable on both the ethernet interfaces of End Point A and End Point B. It is mainly used to connect VLANaware networks. When an interface is in Trunk mode, it forwards only those tagged frames whose VLAN ID matches with aVLAN ID present in trunk table. All other frames will be dropped.Figure 4-47 VLAN operation in Trunk ModeTo enable Trunk mode, click ADVANCED CONFIGURATION > VLAN > Ethernet and enter the settings as described in thefollowing table:ParameterDescriptionInterfaceVLAN ModeAllow UntaggedFramesDisplays the name of the interface.Select the VLAN Mode as Trunk.Select Enable or Disable for this option.Enable: If this option is selected, an interface in trunk mode forwards both tagged frameswhose VLAN ID matches with one of the VLAN IDs of the trunk table and untagged frames.Disable: If this option is selected, an interface in trunk mode forwards only tagged framesand drops untagged frames.Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 85