Tsunami™ QB-8100 Series (50 Mbps / 12 Mbps)

Installation and Initialization2.1.1 Ethernet Connector (PoE IN and Data)The Ethernet port of the device allows the user to connect to the LAN by using CAT5 Ethernet cable, and also power on thedevice by using the Power over Ethernet (PoE) Injector supplied with the product package.• The device receives 48 VDC via a standard Cat5 cable connected to the Ethernet port.• Maximum power supplied to the device is 19 Watts. The device typically draws less than 13.8 Watts.• The total length of cabling between the Personal Computer and the device cannot exceed 100 meters (includes cablefrom the Personal Computer to the PoE Injector, and the cable from the PoE Injector to the device. Due to DC powerrequirements, the maximum cable length between the PoE Injector and the device is 75 meters.Recommended CableFunctionPower (DC) and Ethernet connectionTypeCat5 UV-shielded and outdoor-ratedImpedance100 ohmsRecommended cablesSTP, 24 AWG, UL ratedMaximum Distance330 feet / 100 metersConnector type, device endShielded RJ45 female, weatherized using weatherproofconnectorConnector type, Power and Ethernet Adapter End Shielded RJ452.1.2 Serial PortThe serial connection is made with an RJ11 to DB9 connector (also referred to as a “dongle”). Connect the RJ11 end to thedevice and connect the serial (DB9) end to your Personal Computer to align the antenna and to enter CLI commands.See the following figure:The connections are as follows:Figure 2-2 Serial ComponentsD-ShellRJ111 NC2 23 44 NC5 1 + 3 + 56 6Tsunami QB-8100 Series (50 Mbps / 12 Mbps) Installation and Management Guide 14